 |  | 
 
Kahrs Remover is for use in preparing a Kährs floor for recoating. Purpose is to take off dirt/grease and/or Kährs Lacquer Refresher. Apply with a Kährs mop.
Dilution Ratios:
Heavy Duty Cleaning: Mix 1.7 - 3.4 oz to 2.2 gallons of water
Polish remover: Mix 16.9 - 33.81 oz to 2.2 gallons of water
Directions:
1. Spread a small amount of the solution onto the floor.
2. Allow it to sit on floor for 3 minutes then agitate with a scrub brush.
3. Remove solution from floor with a clean well wrung mop, using as little water as possible.
*NOTES:
Use EXTREME CAUTION when applying product over Beech wood species. Too much moisture may cause damage to the shorts ends of boards/strips.
Read full product label before beginning. Always test a small, inconspicuous area before treating entire floor. Clean mop pad with warm water and hang to dry.
|
|
Kahrsstore.com, 12 McCullough Drive, Suite 10, New Castle, DE 19720
Tel: 1-888-666-4295 |
|
